Remote Control Unit; Battery Installation; Battery Replacement; Basic Operation - Teac A-R650mkII Manual Del Usuario

Remote control unit

When operating the remote control unit, point it towards the
REMOTE SENSOR on the front panel of the amplifier (or other TEAC
component).
< Even if the remote control unit is operated within the effective
range, remote control operation may be impossible if there are
any obstacles between the unit and the remote control.
< If the remote control unit is operated near other appliances
which generate infrared rays, or if other remote control devices
using infrared rays are used near the unit, it may operate
incorrectly. Conversely, the other appliances may operate
incorrectly.

Battery Installation

1.
Remove the battery compartment cover.
2. Insert two "AAA" dry batteries. Make sure that the batteries are
inserted with their positive "+" and negative "_" poles posi-
tioned correctly.
3. Close the cover.

Battery Replacement

If the distance required between the remote control unit and
main unit decreases, the batteries are exhausted. In this case
replace the batteries with new ones.
For more information about collection of batteries, please
contact your local municipality, your waste disposal service or the
point of sale where you purchased the items.
10

Basic operation

To protect speakers from a sudden high-level signal, turn
1
the VOLUME knob counterclockwise to minimize the
volume.
–∞ (infinity): minimum volume
0dB: maximum volume
Press the POWER switch.
2
The unit enters standby mode, and the standby indicator lights.
Press the STANDBY/ON switch to turn the unit on.
3
The standby indicator goes off.