Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARATION
This lamp can be installed into 5 in. and 6 in. housings.
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list. If any part
is missing or damaged, do not attempt to assemble the product. NOTE: Product is shipped in the 6" installation configuration.
If installing in a 6" housing with ears, no adjustments are necessary. However, if installing in a 6" housing without ears or a 5"
housing, the appropriate instructions must be followed.
Tools required for assembly (not included): Phillips screwdriver
INSTALLATION
For 6" housings
Step 1 (Fig. 1)
Remove existing trim and CFL or incandescent bulbs.
Screw adapter (B) into socket in recessed housing.
Step 2 (Fig. 2a)
Plug base cable connector into lamp
(A).
Step 3 (Fig. 2b)
Carefully route wires into fixture. Push
retrofit into recessed housing until the
trim is flush with the ceiling surface.
Fig. 2
a
A
3
Fig. 1
b
B
Publicidad
Tabla de contenido
