Grounding Instructions; Important Warning - Danby DCR038BL Manual Del Propietário

Safety Instructions
ATTENTION

GROUNDING INSTRUCTIONS

This appliance must be grounded. In
the event of an electrical short circuit,
grounding reduces the risk of electrical
shock by providing an escape wire for the
electrical current. This appliance is equipped
with a cord having a grounding wire with a
grounding plug. The plug must be plugged
into an outlet that is properly installed and
grounded.
WARNING - Improper use of the
grounding plug can result in a risk of electric
shock. Consult a qualified electrician or
serviceman if the grounding instructions are
not completely understood, or if the doubt
exists as to whether the appliance is
properly grounded.
DO NOT USE AN EXTENSION CORD
Use an exclusive wall outlet. Do not connect
your refrigerator to extension cords or
together with any other appliance in the
same wall outlet. Do not splice the cord.

IMPORTANT WARNING

An empty refrigerator is a very dangerous
attraction to children. Remove either the
gasket, latches, lids or doors from unused
appliances, or take some other action that
will guarantee it harmless.
DON'T WAIT DO IT NOW!
Installation
Remove the exterior and interior packings, wipe
the outside thoroughly with a soft dry cloth and
the inside with a wet, lukewarm cloth. Avoid
placing the cabinet in a narrow recess or near
any heat source, direct sunlight, or moisture.
Let air circulate freely around the cabinet. Keep
the rear of the refrigerator 5 inches away from
the wall.
Location
1. Select a place with a strong, level floor.
2. Allow 5 inches of space between the back of
the refrigerator and any adjacent wall.
3. Avoid direct sunlight and heat. Direct
sunlight may affect the acrylic coating.
Heat sources nearby will cause higher
electricity consumption.
4. Avoid very moist places. Too much moisture in
the air will cause frost to form very quickly on
the evaporator, and your refrigerator will have
to be defrosted very frequently.
Operation
To avoid vibration, the cabinet must be set level.
Adjust the level of the refrigerator using the single
leveling leg located on the lower hinge side of the
cabinet.
To start the refrigerator, turn the temperature
control knob to the position corresponding to the
desired cooling. (on the graduated blue dial)
Fig.A
The refrigerator temperature will vary depending
on the quantity of the food stored and on the
frequency with which the door is opened.
To turn the control to the "OFF" position, rotate
the control knob to the "0" setting. After
defrosting and if the refrigerator has been left out
of use for some time, set the control to maximum
for 2 to 3 hours before turning to the desired
position. If the refrigerator is not to be used for
long time periods, disconnect the plug and leave
the door partially open. This will help reduce the
mold/mildew from accumulating inside the
refrigerator cabinet.
Ice Cubes
Ice cube tray is flexible. Twist tray to remove ice
cubes. If the ice cube tray is frozen hard to the
evaporator surface, run a little water over the tray.
Never use a knife or other metal instrument to
remove ice cube tray because this may damage
the evaporator.
1