RiverRidge 06-174 Instrucciones De Ensamblaje página 13

STEP 10
OPTION #1
N
WALL ANCHOR
WITH SCREW
Option #1: Securing to Drywall
1. Position cabinet against wall in desired location. Using a pencil, make small mark on wall through hole
on adjustable anchor bracket (O). Move cabinet away from wall and screw 1 plastic anchor (M) into wall
on pencil mark.
2. Place cabinet against wall, insert 1 screw (N) through hole on adjustable anchor bracket (O), then tighten
to plastic anchor (M).
Option #2: Securing to Drywall and Wood Stud
1. Position cabinet against wall in desired location. Insert 1 screw (N) through hole on adjustable anchor
bracket (O), then tighten through drywall and into wood stud.
*Tip: Adjustable anchor bracket (O) can be adjusted to correct distance from wall to cabinet as needed. Once
adjusted, be sure to re-tighten bracket inside cabinet for stability.
STEP 11
1. Slide drawer into cabinet by sliding drawer slides (Q) into grooves on drawer left side panel (13)
and drawer right side panel (14). Pull drawer out and adjust drawer slides (Q) to be fully
extended against drawer front board (12). Insert 2 machine screws (R) through holes on
drawer left side panel (13) and drawer right side panel (14), then tighten to drawer slides (Q).
2. Attach door (11) to left side panel (2) by inserting 4 screws (G) through screw holes on
hinges (F), then tighten to door (11).
M
O
N
OPTION #2
DRYWALL
N
M
SCREW
ONLY
M
DRYWALL
WOOD
STUD
R R
12
G
G
11
G
G
1
N
2