Glacier bay HD65878-0004 Guía De Uso Y Mantenimiento página 5

Installation (continued)
4
Removing the mounting kits
□
Remove the indexes (G). Loosen the screws (H)
and remove the handles (I). Loosen the set
screws (K) with the Hex wrench (Hex: 2.5mm, L)
and remove the handle seats (J).
□
Loosen the anges (M) from the valve bodys
(N & O). Adjust the rubber washers (P), metal
washers (Q) and mounting nuts (R) to the
bottom of valve bodys (N & O).
I
J
6
Installing the handle
□
Place the handle seat (J) onto the right (cold)
ange (M) and tighten set screw (K) with the
Hex wrench (Hex: 2.5mm, L). Place the
handle (I) onto the handle seat (J) and tighten
with the screw (H). Insert the index (G).
□
Place the other handle onto the left (hot) valve
and install the same way.
G
H
I
J
K
M
N
P
Q
R
5
Installing the valve bodies
□
From underneath the deck, insert the cold end
valve (O) with the rubber washer (P), metal
washer (Q) and mounting nut (R) through
the hole on the right (cold) side.
□
From above, thread the ange (M) onto the
valve body (O).
□
Tighten the mounting nut (R) using a basin
wrench, so that the ange (M) sits ush against
G
the nished deck surface.
H
□
Repeat this procedure for the hot end valve (N)
on the left (hot) side.
L
K
M
N
O
P
Q
R
5
Please contact 1-855-HD-GLACIER for further assistance.
NOTE: The hot end valve is identi ed with a label.
O
P
Q
R
J
M
G
H
I
L
K
M
HOMEDEPOT.COM