Craftmade ELLINGTON WOD52ABZ5PC1 Guia De Instalacion página 9

9. Light Kit Assembly (Optional). (cont.)
Thread pull chains through corresponding pull
chain guides on light kit fitter.
Install 2 medium base compact fluorescent
13 watt bulbs (included).
Important: When replacing bulbs, please allow
bulbs and glass shade to cool down before
touching them.
Locate slots on glass shade and align with
nodules on fitter plate. Push up gently on glass
shade and turn in a clockwise direction until it no
longer turns. Pull down gently on glass shade to
make sure that it is secure.
Hg
LAMP CONTAINS MERCURY
Manage in accordance with Spills, Disposal and Site Cleanup
Requirements. In case of breakage, follow clean-up
procedures provided by contacts below.
www.epa.gov/cflcleanup
1-866-284-4010
If you wish to use the fan WITHOUT the light
kit, remove the hex nut and lock washer from the
threaded rod at the top of the light kit fitter.
Unscrew the switch housing cap to remove it
from the light kit fitter and then gently feed the
BLUE (or BLACK) and WHITE wires (one by one)
from the light kit fitter through the hole in the
middle of the switch housing cap.
Locate center cap in one of the hardware packs
and place firmly in hole in middle of switch
housing cap. Align holes in switch housing cap
with holes in switch housing. Re-insert screws
that were removed on previous page and
securely tighten all 3 screws with a Phillips
screwdriver.
pull chain
guide
bulb
switch
housing cap
switch housing
cap
center cap
page 8
light kit fitter
slot
glass shade
hex nut
lock washer
molex
connections
light kit fitter
switch
housing