FireFriend DF-6510 Manual De Instrucciones página 14

After filled the bio-ethanol, please ignite it as described under "Igniting Bio-ethanol
•
fireplace ".
Forbidden to pour bio-ethanol onto an active fire or in the fire compartment if it is
•
still hot.
Forbidden to extinguish the fire with water! Please always proceed as described
•
under " Extinguishing fireplace".
When spilled the bio-ethanol out, wiping up it immediately and then using water to
•
wipe the affected area again so there is no risk of it accidentally igniting. If you
have spilled ethanol on or next to the fireplace, please also check whether there is
any ethanol in the bottom part of the device. If is, wipe it up and then wipe the
affected area off with water.
While filling the fireplace, smoke, eat or drink is not allowed.
•
Forbidden to fan the fire (e. g. using a hair dryer).
•
Always store the bio-ethanol in a sealed and designated container.
•
As the bio-ethanol is high flammability, the place of storage must be cool, not
•
exposed to direct sunlight, and away from intense heat sources or open flames.
You should not store quantity above 5 liters of it in your home.
Despite all safety precautions, If a fire breaks out, you could use the
•
alcohol-resistant foam or carbon dioxide as extinguishing agents.
It is necessary that you keep an adequate extinguisher at hand close to the fire.
•
Environmental conditions
Do not set up the device in an area with cross breeze.
•
Do not move near by the fire during use.
•
Danger of burn
The product and its components become hot during use and also remain hot for
•
some time after the fire has been extinguished. It is only allowed to touch it after
the product cooled off completely.
Safety notices specific to the product
Concerning to setup and use, compliance with national regulations and local
•
provisions is to be observed and practiced.
If the unit is defective, do not try to repair it yourself. In the event of damage,
•
contact a qualified repairman.
Do not clean the product before it cool off completely!
•
Do not clean the product by using any aggressive abrasives, caustic chemicals or
•
Care and Maintenance
Attention: Danger of burn due to hot surfaces!
13