Bahco BCL32G1 Traducción De Las Instrucciones Originales página 9

4. Do not charge the battery pack in the rain, snow or high temperature environment.
5. D o not charge battery pack when environment temperature is below 0°C (32°F) or above
40°C (104°F).
6. W hile charge the cool battery pack (below 0°C) in the warm indoor, keep the battery pack in
the room for one hour to warm up before starting the battery pack.
7. R emove the plug after finishing the charge.
8. The charger should be cooled at least one hour after continue charging three times.
9. Do not use generator for charging the battery pack.
8. TOOL OPERATION
Cartridge Loading
1. Draw back plunger handle fully until the groove of piston rod is latched into the slot on the
tube cap. See Fig. 1
Grease Container ASS'Y
Container Tube
2. Unscrew the grease container from the gun.
3. Remove the cover from new grease cartridge and insert cartridge into the container tube.
Then remove the pull tab. See Fig. 2.
Cover
4. Screw grease container ass'y into grease gun.
5. Release the piston rod from slot and push it all the way in.
6. This gun is ready to use. If your gun fails to work, it is due to air pocket in the grease
container ass'y. To remove the air, procedure as following:
Cartridge Loading
1. Continue to hold trigger switch meanwhile press/release air vent valve until trapped air is
removed.
2. I f the gun still fails to work. Draw back the piston rod fully and "Engaging" it with plunger by
rotating the plunger handle about 1/4 ~ 1/2 turns to set the position of key. See Fig. 3.
3. Press/release air vent valve several times to release the air when push plunger handle.
4. Repeat item 1. procedure until trapped air is removed.
5. "Disengaging" the plunger by rotating the plunger handle about 1/4 ~ 1/2 turns.
Push plunger rod all the way in.
Tube Cap
Groove
Slot
• 9 •
Piston Rod
Plunger Handle
New Grease Cartridge
Pull Tab
Fig. 1
Fig. 2