Unpacking Your Refrigerator; Proper Air Circulation; Electrical Requirements - Kenmore 255.99742 Manual De Uso Y Cuidado

Unpacking Your Refrigerator
1. Remove all packaging material. This includes the foam base and all adhesive
tape holding the refrigerator accessories inside and outside. Slide out and
remove the plastic or foam guard used to protect the compressor from shipping
damage due to vibration and shock.
2. Inspect and remove any remaining packaging, tape or printed materials
before powering on the refrigerator.
3. Check to be sure you have all accessories and parts listed in the Parts and
Features section.
Proper Air Circulation
To ensure that your refrigerator works at the maximum efficiency it was
designed for, you should install it in a location where there is proper air
circulation, plumbing and electrical connections.
The following are recommended clearances around the refrigerator :
Sides ................... 3/4" (19mm)
Top ...................... 2" (50mm)
Back .................... 2" (50mm)
Electrical Requirements
Make sure there is a suitable power outlet (115 volts, 15 amps outlet) with
proper grounding to power the refrigeraton
WARNING: Avoid the use of three prong adapters. NEVER cut off the
third grounding prong in order to accommodate a two prong outlet.
Cutting off the grounding prong is a dangerous practice since it provides
no effective grounding for the refrigerator and may result in serious injury
from electrical shock.
Installation
Your refrigerator is designed for freestanding installation ont4 It should not be
recessed or built-in. Place the refrigerator on a floor strong enough to support it fully
loaded. When moving the refrigerator, never tilt it by more than a 45 degrees angle. This
could damage the compressor and the sealed system.
tf the refrigerator has been tilted more than 45 degrees, let it stand in an upright
position for at least 24 hours prior to plugging it into the power source. This
will allow the refrigerant to settle and reduce the possibility of a malfunction in
the cooling system.
Plug the refrigerator into an exclusive, properly installed grounded wall outlet.
Do not plug another appliance into the same outlet as the refrigeraton
Do not under any circumstances cut or remove the third (grounding) prong from
the power cord. Any questions concerning power and/or grounding should be
directed toward a certified electrician or a Sears or other qualified service dealer
After plugging the appliance into a wall outlet, allow the unit to cool down for
2-3 hours before placing food into the refrigeraton
Installation Limitations
Do not install your refrigerator in any location not properly insulated or
heated, such as a garage, etc. Your refrigerator was not designed to operate in temperature
settings below 55 ° Fahrenheit. Select a suitable location for the refrigerator on a hard
even surface away from direct sunlight or heat sources, such as radiators, baseboard heaters,
cooking appliances, etc.
Leveling Feet
There are two leveling feet on the bottom of the unit near the unit front. Turn the leveling
foot knobs to the left to raise the cabinet, and to the right to lower the cabinef.
3 4
6/8/10