Playing A Disc; Installing The Software - Brigmton BTC-404-N-M-R Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PLAYING A DISC

- Place the disc on the turntable. If necessary, be sure to attach the adapted.
- Select the desired playback speed using the speed selection switch between 33.3, 45 and 78rpm.
- Turn the rotary power switch and select the volume.
- Raise the arm retaining clip.
- Raise the arm slightly.
- Place the needle vertically on the first track and the turntable starts to spin automatically.
- Slowly lower the needle on the disc to be played.
- When the disc comes to an end, the record player will automatically stop if auto stop switch is in the ON
position. If the switch is in the OFF position then continue turning until the tone arm returns to the rest
position.
- Lift the tone arm and place in the holder when finished.
- Replace the protective cap over the needle and close the lock arm.

INSTALLING THE SOFTWARE

- Place the supplied CD into the drive of your computer, follow the instructions and the software will
automatically install as follows:
- Click 'Next'
- Select 'I accept' option then click 'Next':

Publicidad

Tabla de contenido
loading

Tabla de contenido