Garden Treasures HERRINGTON 811049 Manual Del Usuario página 4

ASSEMBLY INSTRUCTIONS
For Bar Table
(Note: short post, connector and long post
STEP 1:
are preassembled together in the factory.
Tighten them before you assemble the bar
table.) Screw short post (C) into connector
(E), and then screw long post (D) into other
end of connector (E) as shown in Fig. 1.
Place base (B) on the floor and screw in the
post assembly.
STEP 2: Place table top (A) on short post (C) and care-
fully screw into place.
Screw umbrella set screws (AA) into side of
short post (C).
Screw adjustable feet (BB) into the bottom of
base (B). Then use adjustable feet (BB) to
level the table as shown in Fig. 2.
Hardware Used
Umbrella Set Screw
Adjustable Feet
4
Umbrella Set Screw Hole
2
6
Fig. 1
Fig. 2