Technical Support - Tripp-Lite WEBCARDLX El Manual Del Propietario

Installation
3-4
The card will display a Linux-style login after boot up. Login as
localadmin / localadmin to get the standard menu.
Note: User names and passwords are case sensitive.
3-5
From the main menu:
a. Select Option 3: Network Configuration
b. Select Option 1: IP Configuration
c. Select Option 3: IPv4 setting on Option 4: IPv6 settings
d. Select Option 1: Method
e. Select Option 2: Static
Assign the address, subnet mask, gateway, etc. Save your settings by selecting
"A" (apply). Choose "y" to restart PowerAlert now. Close your terminal session.
3-6
Remove Cable: Remove the cable and proceed to 4 - Test and Configure.
4 - Test and Configure
4-1
Test Network Connection: After an IP address has been assigned to the card,
try to access it with a Web browser. Open Firefox or Chrome on a computer
connected to the network and enter http:// or https:// followed by the IP address.
The login screen for PowerAlert Device Manager will display. The default user
name is localadmin and the password is localadmin. After you enter the user
name and password, the PowerAlert Status page will appear in the browser
window. For more information about configuration and operation of the managed
device, refer to the WEBCARDLX / WEBCARDLXMINI User's Guide located in the
support section of the WEBCARDLX or WEBCARDLXMINI product web page.

Technical Support

Technical Support can be found at: www.tripplite.com/support
7