LG DLE1501W Manual Del Proprietário página 20

20
INSTALLATION INSTRUCTIONS
Connecting Gas Dryers (cont.)
WARNINg
To reduce the risk of fire, electric shock, or injury
to persons when using this appliance, follow basic
precautions, including the following:
• Installation and service must be performed by
a qualified installer, service agency, or the gas
supplier. Failure to do so can result in fire, explosion,
or death.
• Use only a new stainless steel flexible connector
and a new AGA-certified connector. Failure to do so
can result in fire, explosion, or death.
• A gas shutoff valve must be installed within 6 ft.
(1.8 m) of the dryer. Failure to do so can result in fire,
explosion, or death.
• The dryer is configured for LP(Liquefied Propane)
Gas when shipped from the factory. Make sure
that the dryer is equipped with the correct burner
orifice for the type of gas being used (Natural Gas
or Liquefied Petroleum). Failure to do so can result in
fire, explosion, or death.
• If necessary, the correct orifice (For the Natural
orifice package, order part number 383EEL3002K)
should be installed by a qualified technician and
the change should be noted on the dryer. Failure to
do so can result in fire, explosion, or death.
• All connections must be in accordance with local
codes and regulations. Failure to do so can result in
fire, explosion, or death.
• Gas dryers MUST exhaust to the outdoors. Failure to
do so can result in fire, explosion, or death.
3/8" NPT Gas
Connection
AGA/CSA-Certified
Stainless Steel Flexible
Connector
1/8" NPT Pipe
Plug
Gas Supply
Shutoff Valve
connecting the gas supply
1. Make sure that the gas supply to the laundry room is
turned OFF. Confirm that the type of gas available in
your laundry room is appropriate for the dryer. The
dryer is prepared for LP(Liquefied Propane) Gas with a
3
⁄₈ - inch NPT gas connection.
2. Remove the shipping cap from the gas connection
at the back of the dryer. Be careful not to damage
the threads of the gas connector when removing the
shipping cap.
3. Connect the dryer to your laundry room's gas supply
using a new flexible stainless steel connector with a
- inch NPT fitting.
4. Securely tighten all connections between the
dryer and your laundry room's gas supply. Turn on
your laundry room's gas supply and check all pipe
connections (both internal and external) for gas leaks
with a noncorrosive leak-detection fluid.
electrical connection
3/8" → 5/16"
NPT coupling
(from dryer to
hose – gas tank)
3/8" → 1/2"
NPT coupling
(from dryer to
pipe –gas pipe)
AGA/CSA-Certified
Stainless Steel Flexible
High-altitude installations
The BTU rating of this dryer is AGA-certified for
elevations below 3048 meters.
If your gas dryer is being installed at an elevation above
3048 meters, it must be derated by a qualified technician
or gas supplier.
Plug dryer into a 120 V~
60 Hz grounded 3-prong
outlet.
Gas Supply
Shutoff
Valve
Connector
3
⁄₈