Figure 2
11
Figure 3
Tension Knob
Figure 4
PAGE 2 OF 9
ASSEMBLY CONTINUED
8
9
10
2. Align armrest with holes on bottom of seat cushion.
Use one 1/4 x 1⁄" screw (8) and two 1/4 x 1⁄" screws
(11) to attach. Repeat on opposite side. (See Figure 2)
NOTE: Use Allen wrench to tighten all screws.
3. Align mechanism with holes on bottom of seat
cushion with tension knob facing the front of seat.
Use four 5/16 x 1" screws (9) to attach. (See Figure 3)
4. Position back support in slot between bottom of seat
cushion and mechanism. Align holes and use three
5/16 x 3/4" screws (10) to attach back support to
mechanism. (See Figure 4)
0721 IH-4114