Operating Mode - Kolver PLUTO Serie Manual De Instrucciones

WARNING: To reduce the risk of injury, before using or servicing screwdriver, read and
understand the following information as well as separately provided safety instructions (item
code: 0MS000). The features and descriptions of our products are subject to change without
prior notice.
DECLARATION OF USE
Screwdriver (class I) suitable for industrial environment only. It shall be used for tightening. No
other use will be permitted. For professional use only.
DATA
Noise level: < 70 dB(A) (EN 60 745).
Vibration level: < 2.5 m/s² (EN 60 745).
Declaration of noise and vibration emission
These declared values were obtained by laboratory type testing in compliance with the stated
standards and are not adequate for use in risk assessments. Values measured in individual work
places may be higher than the declared values. The actual exposure values and risk of harm
experienced by an individual user are unique and depend upon the way the user works, the work
piece and the workstation design, as well as upon the exposure time and the physical condition
of the user. We, KOLVER, cannot be held liable for the consequences of using the declared
values, instead of values reflecting the actual exposure, in an individual risk assessment in a
work place situation over which we have no control.

OPERATING MODE

The screwdriver can be manual or used as fixed spindle on an automatic machine.
Manual screwdriver

Fit the screwdriver with a suitable fastening accessory, then connect it to the control
unit.

Hold the screwdriver by the handle and apply to the fastener to be tightened.

Press the lever to start the screwdriver.

The screwdriver stops when the preset torque is reached.

For each second of operation, the motor needs to rest for 3 seconds.

Failure to do so may result in motor overheating and damage.

That will be considered as a misuse and the warranty will not be applied.
As the reaction increases in proportion to the tightening torque, make sure that the screwdriver is
in perfect working and the control unit is programmed correctly, to reduce the risk of injury to
the operator as a result of unexpected behaviour of the screwdriver.
Control and software
Power source by EDU2AE series, depending on the model.
LUBRICATION
Do not grease too much gears or bearings; a thin coat shall be sufficient.
Grease after 300.000 cycles.
EN