Technical Specifications - Audio Unlimited SPK-VELO-003 Manual Del Usuario

TECHNICAL SPECIFICATIONS

Transmission Mode : UHF
Carrier Frequency : 900 MHz Digital Hybrid
Operation Voltage : Transmitter, DC 12V 200mA
Speakers, 6 X 'C' size Alkaline batteries or DC 9V 1A adaptor
Remote Control Unit, 2 X 'AAA' size batteries
Frequency Response : 40Hz – 12KHz
Distortion : 1%
S/N Ratio : 65dB (typical)
Operation Distance : Up to 150 feet
Speakers : 2-way
Output Power : 2 x 5Watts
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
P.10
This product may contain chemicals listed in Proposition 65
http://www.oehha.ca.gov/prop65/prop65_list/Newlist.html
(
be known to cause cancer, birth defects or other reproductive harm.
ATTENTION:
The transmitter for this speaker set is designed to work with a wide variety
of devices. Our tests show the default volume levels of iPods, MP3 players
and other devices connected to the transmitter through the headphone jack
does not have the signal strength required by the transmitter. Raising the
volume of your device will increase the signal strength to the transmitter.
The blue signal LED will switch from flashing to steady when the required
signal strength from your device is reached. We recommend that you keep
the volume set on your iPod or MP3 player at a minimum of ¾ of full
volume.
WARNING:
When powering by AC household current, these devices must be used with
the AC/DC adapters supplied within the package. Do not attempt to power
utilizing other AC or DC adapters. Power adapters are for indoor use
only – do not use in wet areas or weather.
)
that may
P.11