Important Notice; English - Corsair HYDRO Serie Manual De Instrucciones

IMPORTANT NOTICE

Quick Start Guide is a general installation guide and does not cover the specifics of individual case or
radiator mounting.
CORSAIR recommends you thoroughly leak-test your custom cooling system for at least 24 hours to ensure
that the system is securely sealed and operating reliably. CORSAIR warranty does not cover any hardware
damage resulting from poorly executed, improper and otherwise hasty assembly of your custom water-
cooling system.
Disassembly of CORSAIR HYDRO X products is highly discouraged due to complex design of components.
Such action may result in irreparable mechanical, electrical or chemical damage that may void the warranty.
For an exact and up-to-date product compatibility list, please refer to CORSAIR website.
PREREQUISITES (NOT INCLUDED)
A — x1 PHILLIPS-HEAD SCREWDRIVER
INSTALLATION
Precaution: Take care to discharge any electrostatic charges.
1. Power down your system.
2. Identify an available M.2 key M 2280 slot on
your system, referring to your motherboard or
system documentation.
A
3. Remove any cover from the M.2 slot and
screws. Take care to ensure no screws
remain on standoffs for shorter M.2 cards.
1
4. Insert and secure M.2 with screw.
4
5
5. Install the two (2) appropriate CORSAIR XF G1/4''
BSPP threaded-type fittings (not included) into
the water block ports and tighten them by hand.
Do not use any tools to tighten (i.e. pliers)
6. Install tubing and secure it to finalize the
adding of the water block to the water-cooling
loop. Do not forget to leak test the system
before fully powering on your PC.
7. Flow orientation is not important. This product works great with flow in either direction.
2

ENGLISH