Safety Instructions - Reloop Stand Hub Manual De Instrucciones

CAUTION! For your own safety, please read this operation manual carefully
before initial operation! All persons involved in the installation, setting-up,
operation, maintenance and service of this device must be appropriately
qualified and observe this operation manual in detail. This product complies
with the requirements of the applicable European and national regulations.
Conformity has been proven. The respective statements and documents are
deposited at the manufacturer.
Please remove the Reloop Stand Hub from its packaging. Check before initial operation
to make sure that the device has not been visibly damaged during transport. If you detect
any damage to the power cable or the casing, do not operate the device. Contact your
specialised dealer.

SAFETY INSTRUCTIONS

CAUTION! Please exercise particular caution when handling 115 V, 60 Hz and
230 V, 50 Hz power voltage. This voltage rating may lead to a critical electrical
shock! Any damage caused by the non-observance of this operation manual
excludes any warranty claims. The manufacturer is not liable for any damage to
property or for personal injury caused by improper handling or non-observance
of the safety instructions.
- This device left the works in perfect condition. To maintain this condition and to ensure a
risk-free operation the user must observe the safety instructions and warnings contained
in this operation manual.
- For reasons of safety and certification (CE) the unauthorised conversion and/or
modification of the device is prohibited. Please note that in the event of damage caused
by manual modification to this device any warranty claims are excluded.
- The inside of the device does not contain any parts which require maintenance, with the
exception of wear parts that can be exchanged from the outside. Qualified staff must
carry out maintenance, otherwise the warranty does not apply!
- Ensure that the power will only be supplied after the device has been fully set up.
- Only use cables that comply with regulations. Observe that all jacks and bushes are
tightened and correctly hooked up. Refer to your dealer if you have any questions.
- Ensure that when setting up the product, the mains cable is not squashed or damaged
by sharp edges.
- Prevent the mains cable from coming into contact with other cables! Exercise great care
when handling mains cables and connections. Never touch these parts with wet hands!
- Connect the power cable exclusively to appropriate shock-proof outlets. The only supply
point to be used is a supply outlet in accordance with specifications of the public supply
network.
- Disconnect the device from the supply outlet when not in use and before cleaning! Be
sure to hold the mains plug by the body. Never pull the mains cord! When not using the
turntable for longer periods of time, close the dust guard.
- Position the device on a horizontal and stable low-flame base. When experiencing
feedback, direct the radiation field of your loudspeakers away from the device.
- Avoid any concussions or violent impact when installing or operating the device.
- When selecting the location of installation make sure that the device is not exposed to
excessive heat, humidity, and dust. Be sure that no cables lie around openly. You will
endanger your own safety and that of others!
- Do not rest any containers filled with liquid that could easily spill onto the device or in its
immediate vicinity. If, however, fluids should access the inside of the device, immediately
disconnect the mains plug. Have the device checked by a qualified service technician
before re-use. Damage caused by fluids inside the device is excluded from the warranty.
5b
2
4
3
- Do not operate the device under extremely hot (in excess of 35° C) or extremely cold
(below 5° C) conditions. Keep the device away from direct exposure to the sun and heat
sources such as radiators, ovens, etc. (even during transport in a closed vehicle).
- The device must not be operated after being taken from a cold environment into a warm
environment. The condensation caused hereby may destroy your device. Do not switch
on or operate the device until it has reached ambient temperature!
- This device should only be cleaned with a damp cloth. Never use solvents or cleaning
fluids with a petroleum base for cleaning.
- When relocating, the device should be transported in its original packaging or the
included nylon bag.
- Devices supplied by voltage should not be left in the hands of children. Please exercise
particular care when in the presence of children.
- At commercial facilities the regulations for the prevention of accidents as stipulated by the
association of professional associations must be observed.
- At schools, training facilities, hobby and self-help workshops the operation of the device
must be monitored with responsibility by trained staff.
- Keep this operation manual in a safe place for later reference in the event of questions
or problems.
APPLICATION IN ACCORDANCE
WITH REGULATIONS
- This device is a professional laptop stand with integrated USB hub. To use the integrated
USB hub, the stand must be connected to a laptop or smart device.
- This product is approved for connection to a standard USB power supply with a maximum
of 60W and is designed for indoor use only.
- If the device is used for any other purposes than those described in the operation manual,
damage can be caused to the product, leading to exclusion of warranty rights. Moreover,
any other application that does not comply with the specified purpose harbours risks such
as short circuit, fire, electric shock, etc.
- The serial number determined by the manufacturer must never be removed to uphold
the warranty rights.
MAINTENANCE
- Check the technical safety of the device regularly for damage to the mains line or the
casing.
- If it is to be assumed that the safe operation is no longer feasible, then the device must
be disconnected and secured against accidental use. Always disconnect the mains plug
from the outlet!
- It must be assumed that a safe operation is no longer feasible, if the device bears visible
defects, if the device no longer functions, following longer storage under unfavourable
conditions or after major transport stress.
1
4
5a
3
6
9
10 11 12
7
8