Garmin GHS 20 Instrucciones De Instalación página 6

7. When the handset makes a sound, select
OK on the handset to complete the
pairing.
8. Repeat steps 4–7 for each additional
handset.
After a handset has been paired with
the GWH 20, you do not need to pair it
again. It will connect automatically when
the handset and radio are both turned on.
Pairing Troubleshooting
If you are not able to pair a GHS 20/20i
handset with the GWH 20, complete these
steps.
• Make sure all the handsets you want to
pair are turned on.
• Make sure the GWH 20 is connected to
the microphone relocation port of the
VHF 200/200i radio or to STATION 3 of
the VHF 300/300i radio.
• When pairing the handsets for the first
time, make sure the handsets are close
to the GWH 20 (within 3 ft (1 m) if
possible).
EN-6
• You can connect up to three GHS 20/20i
handsets to the GWH 20. If you have
three handsets paired with the GWH 20,
and you are attempting to replace one
of them, you must first disconnect the
handset you are replacing
Renaming a Paired GHS 20/20i
1. On the VHF 200/200i or on a handset
connected to the VHF 300/300i, select
MENU > COMMUNICATIONS >
CONNECTIONS > [Device Name] >
NAME.
2. Enter all the letters in the new name
using the Channel knob (up to 12
letters).
3. Select ACCEPT.
Disconnecting a GHS 20/20i From
the GWH 20
If you must replace a GHS 20/20i handset
because one is lost or damaged, for the
best results, disconnect, or unpair, the
handset you are replacing before pairing the
replacement handset to the GWH 20
(page 5).
GHS 20/20i Installation Instructions
(page 6).