How To Assemble Your Ceiling Fan (Downrod) - Famination Distinction A1 Serie Manual Del Propietário

How to Assemble Your Ceiling Fan (Downrod)

1. Remove the hanger ball portion from the downrod
/hanger ball assembly by loosening the set screw
in the hanger ball until the ball falls freely down the
downrod. Remove the pin from the downrod, then
remove the hanger ball. Retain the pin and
hanger ball for reinstallation in Step 5. (Figure 1)
2. Remove the hairpin clip and clevis pin from the
bottom of downrod. Retain the pin and clip for
reinstallation in next step. (Figure 2).
3A. For A1 & C1
The fan comes with black,white, blue and green wires.
Separate and untwist the four wires and route them
through the downrod. Align the clevis pin holes in the
downrod with the holes in the downrod support.
Install the clevis pin and secure with the hairpin clip.
(Figure 3A)
3B. For D1
The fan comes with black, white and green wires.
Separate and untwist the three wires and route them
through the downrod. Align the clevis pin holes in the
downrod with the holes in the downrod support.
Install the clevis pin and secure with the hairpin clip.
(Figure 3B)
Downrod
Set Screw
Hairpin
Clip
Downrod
Hairpin Clip
Downrod
Hairpin Clip
7
Pin
Hanger Ball
Figure 1
Clevis Pin
Figure 2
Black, White, Blue
and Green wires
Clevis Pin
Figure 3A
Black, White and
Green wires
Clevis Pin
Figure 3B