Maintenance | Service - sanisplit MOD. 600 Instrucciones De Instalacion Y Uso

Fix the water thank unit with two crew plugs (Ø 3,5 mm) or similar, using the fixing holes.
Sanisplit (Type: Sanisplit 1, 2, 3 Combi) can be connected to any type of toilet having a wall
discharge in accord to European standards.
It is connected by inserting the toilet discharge into the rubber coupling on the tank and fixing
it with the clamp supplied (Fig. 1).
The outlet and other units of bathroom or kitchen equipment are connected to the back of
the appliance (Fig. 2), so all those pipes, connectors, valves etc. that inevitable spoil the
appearance can disappear. However it's possible to connect pipes externally (Fig. 3, Fig. 4 and
Fig. 5). Bathroom or kitchen items must be connected as shown in Fig. 2. For dishwashers and
washing machines only, can be utilized either of the two inlet connections.
It is recommended the use of 1 Sanisplit for bathroom or kitchen. In any case do not connect
to Sanisplit more than 1 appliance operating potentially continuously (es. no more than 1
shower)
N.B.: The shower plate and bathtub must be at least 20 cm above floor level (Fig. 6).
All sanitary equipment connected must allow the interruption of water flow.
Sanisplit has tank ventilation as shown on Fig. 6.
The product includes a tank unit fixed permanently to the toilet and/or the other devices and
a second extractable unit including the macerator pump and the pressure switch.

2.3. Maintenance | Service

The user must carefully take care of all warning and precautions to minimize maintenance
and repair operations.
In case of operation failure (partial obstructions, misure, etc.) press the manual start button
located on the side of the device (Fig. 8) until the problem is resolved.
Press for no more than 20 consecutive seconds to a max of 3 cycles.
To remove potential obstructions in the macerating chamber, the maintenance operation is
a simple operation directly executable by the same user in a few steps:
1. Unplug the power cord.
2. Remove the side cover of the device as shown in Fig. 9.
3. Remove the drainage cap from the tank unit after preparing to collect water as shown in
Fig. 10.
4. Unscrew the knob on the opposite side of the device as shown in Fig. 11.
5. Detach the removable unit and remove any obstruction from the macerating chamber as
shown as shown in Fig. 12.
6. Once the maintenance is completed, reattach the removable part by tightening the knob
up unit it is firmly connected to the tank collection unit.
2.4. Fast Assistance Service (F.A.S.) | Replacing the extractive unit
Tecma S.r.l.
Via Flaminia | Loc. Castello delle Formiche
05030 Otricoli (TR)
ITALY
T +39 0744 709071
F +39 0744 719833
info@tecma.eu
www.thetfordresidential.com
7