Mode Change - 8dTek COMBO JET TSM8800 Manual Del Usuario

T M
AD INSTRUMENTS
(5.) Blind 12MHz: Blind scan the frequency from 950-2150 by 12 MHz increment
Note: In the course of signal finding, the bar meter of the LEVEL and
QUALITY indicates the signal strength and quality. The numerical
value of S/N, FEC, BER. DiSEqC indicates which port is connected
to DiSEqC1.0 switch.
Adjust the dish until you get the maximum of signal level and quality.
Once the signal is set, the LOCK light will automatically switch on.
Press F1 key to enter ZOOM mode, you may notice beeping sounds as
audio indicator which may change its tone/frequency according to the
signal strength.
2.MODE CHANGE: Press F1 to shift the display mode between Normal /
Zoom/ in the signal finding menu.
Zoom mode
<Figure2-6>
<Figure2-7>
DTVLINK
9