Important Safety Instructions - Dyno EasyStitcher Manual De Operación

IMPORTANT SAFETY INSTRUCTIONS

When using and electrical appliance, basic safety precautions should always be followed, including the
following:
Read all instructions before using this sewing machine.
DANGER
–
To reduce the risk of electric shock:
1. An appliance should never be left unattended when plugged in. Always unplug this appliance from
the electrical outlet immediately after using and before cleaning.
2. Do not reach for an appliance that has fallen into water. Unplug immediately.
3. Do not place or store appliance where it can fall or be pulled into a tub or sink. Do not place or drop
into water or other liquid.
WARNING
–
To reduce the risk of burns, fire, electric shock or injuries to persons:
1. Keep fingers away from all moving parts. Special care is required around the sewing machine needle.
2. Always use the proper needle plate. The wrong plate can cause the needle to break.
3. Do not use bent needles.
4. Do not push or pull fabric while stitching. It may deflect the needle causing it to break.
5. Switch the sewing machine off ("O") when making any adjustments in the needle area, such as
threading needle, changing needle, threading bobbin, or changing presser foot, etc.
6. Always unplug sewing machine from the electrical outlet when removing covers, lubricating or when
making any other user servicing adjustments mentioned in the instruction manual.
7. Do not allow to be used as a toy. Close attention is necessary when this appliance is used by or near
children.
8. Use this appliance only for its intended use as described in this manual. Use only attachments
recommended by the manufacturer as contained in this manual. Never operate on a soft surface such
as a bed or couch where air openings may be blocked.
9. Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has
been dropped or damaged, or dropped into water. Return the appliance to the nearest authorized
dealer or service center for examination, repair, electrical or mechanical adjustment.
10. Never operate the appliance with any air openings blocked. Keep ventilation openings of the sewing
machine and foot controller free from the accumulation of lint, dust and loose cloth.
11. Never drop or insert any object into any opening.
12. Do not use outdoors.
13. Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
14. To disconnect, turn all controls to the off position, then remove plug from outlet.
15. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
16. Connect the appliance to a properly grounded outlet only. See Grounding Instructions.
SAVE THESE INSTRUCTIONS
This sewing machine is intended for household use only.
GROUNDING INSTRUCTIONS
This product must be grounded. In the event of malfunction or breakdown, grounding provides a path of
least resistance for electric current to reduce the risk of electric shock. This product is equipped with
a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into
an appropriate outlet that is properly installed and grounded in accordance with all local codes and
ordinances.
DANGER –
Improper connection of the equipment-grounding conductor can result in a risk of electric
shock. The conductor with insulation having an outer surface that is green with or without yellow stripes
is the equipment-grounding conductor. If repair or replacement of the cord or plug is necessary, do not
connect the equipment-grounding conductor to a live terminal.
Check with a qualified electrician or serviceman if the grounding instructions are not completely
understood, or if in doubt as to whether the product is properly grounded.
Do not modify the plug provided with the product – if it will not fit the outlet, have a proper outlet installed
by a qualified electrician.
This product is for use on a circuit having a nominal rating more than 120 V and is factory equipped with
a specific electric cord and plug. No adapter should be used with this product. If the product must be
reconnected for use on a different type of electric circuit, the reconnection should be made by qualified
service personnel; and after the reconnection, the product should comply with all local codes and
ordinances.
2