Horizon Global CQT76194 Instrucciones De Instalación página 5

4. (A) Hitch installation - Raise the hitch into position and align bracket holes to the studs on
end panel. Raise bumper beam to sandwich the hitch. Reuse flange nuts from bumper see
Figure 1. If a fourth hole in the bumper is open use items j and k see Figure 5.
Use items 1
and 2 if
accessible
5. Tighten all M10 fasteners with torque wrench to 53 Lb.-Ft. (72 N*M).
Proper torque is needed to keep the hitch secure to the vehicle when towing.
©2017, 2018 Horizon Global™ Corp. - Printed in Mexico
4. (B)After the hitch and bumper has been placed into position gently bend the fascia
mounting tabs as needed to reattach the heat shield and fascia.
6. Fascia trimming and reinstallation – mark the center line on the fascia and trim the area on
fascia as shown in Figure 6. Reinstall all fasteners, wirings, exhaust hanger, and fascia
removed in step 1,2.
3.5''
Sheet 5 of 15 76194NP 2-28-18 Rev. B