JSG Oceana Cubix 005-016 Guía De Instalación Y Cuidado página 3

Vessel Installation Instructions:
Tools and Materials:
1. Inspect sink prior to installation. No returns accepted after installation
unless product is mechanically defected.
2. JSG Oceana vessels have a standard 1 ¾" drain hole which requires a
1 ¼" drain.
3. Drill a hole in your countertop slightly larger than the width of your
drain (no less than 1 3/8" and no larger than 1 ½").
4. Clean the top and underside of the countertop and your vessel.
5. Place a thin rubber washer or bead of silicone between the vessel and
countertop as a buffer. If a rubber washer is used you may also apply
an additional layer of clear caulking or epoxy for added stability.
6. Apply plumber's putty under the rim of the drain and place into sink.
Place the drain through the vessel and hole in the countertop.
7. Tighten drain underneath by hand only. DO NOT OVER-TIGHTEN.
8. If the drain does not have enough threads to tighten completely to the
countertop, purchase a piece of PVC pipe to make up the difference.
Use two rubber washers to seal the PVC pipe and prevent leakage.
(PVC pipe can also be used if you purchase a drain with an overflow
hole.)
9. Wipe away excess sealant and allow sealant time to set, according to
sealant manufacturer's instructions.
10. Complete the water supply and drain connections.
11. Run water into the lavatory and check for leaks.
Codes/Standards Applicable
Specified model meets or exceeds the following:
• IAPMO / UPC & CUPC
• IAPMO / CSA
Sealant