Visual Plus Corporation xpr MTT Guia De Inicio Rapido página 2

3.1 View
3.4 Output Connection for AC Device - Fail Secure
MTT operates in Latch and Pulse mode.
The time is set by Dipswitch setting.
Note: Set the operating time only before
switching on power to the MTT.
If the operating time is to be changed,
select a new time setting and then wait a
few seconds for the circuit to re-adjust
before switching back the power.
Warranty : VPC warrants its products to be free from defects in material and workmanship for 24 months from the date of shipment. The product is to be
installed in accordance with VPC's instructions and the unit should not be modified or tampered with. VPC does not assume any responsibility for
damages arising from misuse of the product. VPC's sole responsibility is limited to the repair or replacement when the product is sent to VPC's facility.
Visual Plus Corporation, Avenue du Congo 11, 1000 Brussels, Belgium.
As per the European Directive's 2002 / 95 / EC & 2002 / 96 / EC
This product is in compliance to the restriction of hazardous substance - ROHS under (Directive 2002 / 95 / EC) and this product should not
be disposed in the municipal waste stream but should be handed over to any designated collection facilities appointed by the government or
the local authorities to enable recovery & recycling as per WEEE (Directive 2002/96/EC). w.e.f 1st july'2006
a Visual Plus Corporation Company
3.2 Application & Wiring
51mm
92mm
3.3 Output Connection for DC Device - Fail Open
Power Supply
~ ~
~
10K 1/2W
470nF
~
4.0 OPERATION
The table illustrates the dipswitch settings in different modes
Operation
Latch Mode
10 Seconds
5 Seconds
3 Seconds
Approvals and Safety standards
Immunity: Meets to EN50082-2 (EN61000-4-2, EN61000-4-3, EN61000-4-4, EN61000-4-5 and EN61000-4-6)
3.5 Backlight ON/OFF
ON
1 2 3 4
Switch 1
ON
ON
OFF
OFF
2
Access Control Device
Request-to-exit
Input
Relay output
Power Supply
- +
+
-
DipSwitch No.3
Backlight ON/OFF
DipSwitch
Switch 2
ON
OFF
ON
OFF
Locking Device
ON
1 2 3 4
ON
1 2 3 4
ON
1 2 3 4
ON
1 2 3 4