EPTA Bonnet Neve MULTIFRESCO PLUS Instrucciones De Uso Para El Usuario página 22

Modello - Modèle - Model
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
19. TEMPERATURE SETTING AND CONTROLS
Each refrigerating appliance is provided with an electronic control for automatic maintenance of the appropriate pre-established
temperature inside the tank.
This temperature adjuster is gauged by the factory and should not be touched by the user.
Only if the average internal temperature is too cold or not cold you can increment or decrement the temperature:
• Press the (Set) (2 sec.) key in order to see on display the temperature set point.
• Press the () key or the () key in order to increment or decrement the temperature set point.
• Press the (Set ) key in order to store the new temperature set point.
20. SIGNIFICANCE OF THE CONTROL UNIT LEDS
MULTIFRESCO PLUS
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
1
2
3
LED MODE
ON
Flashing
ON
Flashing
ON
Flashing
ON
ON
ON
ON
ON
°C
Flashing
ECO
ON
1. Light switch
2. Automatic defrosting button
3. Button to show set temperature
4. Button to decrease temperature
5. Button to increase temperature
MEANING
Active compressor
Delay against close starts
Defrosting in progress
Dripping in progress
Fans on
Fans start delay in progress
A temperature alarm activated
Continuous cycle in progress
Light on
Auxiliary active
Unit of measurement
Programming
Energy saving in process
2 2 / 6 4
PAGE
UM000477
N° DOC
4
5