Appendix Iii - Proper Mounting - Strong Racks SR600R Manual De Instrucciones

•
It is recommended to use a stud finder and physically inspect your crawl space to
locate your truss direction. You can also make note of any electrical, plumbing or
gas lines that may be around your truss system.
•
Always install the lag screws directly into the center of a truss. With appropriate
installation, you should never encounter utility lines.
•
We recommend probing to find the edges of your truss. This is the most reliable
method of finding the center of your truss and ensures proper installation of the
lag screws.
•
Because our lag screws are designed to be contained inside of solid wood
trusses, they are 3" in length. If you find that you have pre-fabricated wood
trusses such as TGI's, we recommend that you slowly tighten your lag screws
into the mounting track. Some pre-fabricated trusses are thin, and your lag
screws may penetrate the back side.
•
If you cannot view your trusses due to a living space being above your garage,
you can purchase 2 ½" steel lag screws to replace the 3" lag screws that are
provided in your hardware kit.
•
In every situation, it is best to consult with your builder or a professional to help
with your project.
Appendix III –
Proper Mounting
24