Important - Lullaby 616 Manual De Instrucciones

5. USE
2
5
5 min.
1
3
5.7 Insert the utensils you want to sterilize in the well (2) and press
button 5 again. The three red LEDs (6) stop flashing and remain
constantly lit. After a few seconds (no more than five), the
sterilisation cycle is completed and the appliance automatically
deactivates. The three red LEDs (6) and the blue indicator (4)
start flashing again.
The appliance is now ready for a new sterilisation cycle.
6
5.8 With due caution, remove the utensils immediately as the
high temperature may damage them.
STANDBY function (see paragraph 3.3)
5.9 The sterilizer enters STANDBY mode automatically after 8
minutes of inactivity; the blue indicator (4) remains lit constantly
and the three LEDs (6) are off.
To perform a new sterilisation cycle, follow the instructions from
paragraph 5.6.
6
5.10 If you intend to sterilise other objects within a short period of
time, close the cover (1) to maintain internal temperature.
IMPORTANT: for more efficient operation, keep the appliance
switched on throughout the working day.
5.11 If no more sterilisation cycles are required, it is advisable to turn
the appliance off with the main switch (3), leaving the cover
open to allow heat to escape. Once cooled, close the cover to
protect the quartz beads.
5.12 The sterilizer switches off automatically after 4 hours of
inactivity. To reactivate, follow the instructions from paragraph
5.5.
IMPORTANT: Using the appliance to sterilise utensils with
plastic, wooden or brass parts is not recommended.
ON
6
4
Stand-by
GB
4