Start Treatment - NonDolens ELECTROACU PEN Manual De Uso

4
5
6
Note: Always begin with the lowest setting. The intensity can
be adjusted any time during the treatment.
7 HOW TO FIND THE ACUPUNCTURE POINT
Connect earphone to the earphone jack.
Slide power switch (H) from 0 to I to turn on the unit and go to
the standby mode. A signal tone will sound.
Hold the device like a pen while touching the metallic contact
area (K). Slide copper tip (I) over the skin with gentle pressure.
The skin must be clean (not oily), dry and free from injuries. The
signal tone will increase when nearing the acupuncture point.
8 & 9 START TREATMENT
Press start button (B). The green status display (A) will flash
during the treatment. After treatment the light will go out and a
signal tone will sound. The treatment can be repeated if
needed.
Note: Press the start button continuously when applying
unlimited time treatment.
7
8
9
05