Makita XTW01 Manual De Instrucciones página 7

2. Press the pin down to remove the inner sleeve
from the outer sleeve.
► 1. Inner sleeve 2. Pin 3. Outer sleeve
NOTICE:
Be careful not to drop the inner sleeve
when removing it.
NOTICE:
Do not remove the tip rod, tip rod
spring, and inner sleeve spring from the tool.
► 1. Tip rod 2. Tip rod spring 3. Inner sleeve spring
Installing the outer and inner
sleeves
Place the inner sleeve with the pin facing upward.
Attach the outer sleeve to the inner sleeve securely
while pressing the pin of the inner sleeve.
► 1. Outer sleeve 2. Pin 3. Inner sleeve
Insert the outer and inner sleeves into the tool while
rotating the inner sleeve clockwise and counterclock-
wise until the outer sleeve touches the tool. Tighten the
two screws firmly.
1
2
3
1
► 1. Outer sleeve 2. Screw
2
NOTICE:
the outer sleeve and the tool.
3
OPERATION
CAUTION:
all the way until it locks in place. If you can see the
red indicator on the upper side of the button, it is not
locked completely. Insert it fully until the red indicator
cannot be seen. If not, it may accidentally fall out of
the tool, causing injury to you or someone around
you.
1
CAUTION:
ground, floor, walkways, etc. to prevent injury
from tripping or falling.
2
1. Tighten bolts preliminarily by using a hand wrench.
3
7 ENGLISH
Make sure that there is no gap between
Always insert the battery cartridge
Keep the bolt tips off of the
1
2