STMROBOTICS STM-465 Manual Del Usuario página 23

Overview of your heat press
1. Pressure knob: It is used to raise or lower the pressure.
2. Display: Displays temperature and time.
3. Control buttons: Used to adjust the heat press settings.
4. Power switch: It is used to turn on or off the heat press.
5. Heating plate: This plate will heat to the temperature set once the heat press is turned ON.
6. Base: It is used to even the pressure while sublimating.
7. Handle: It is used to raise and lower the heat press.
Figure 1. STM-46S Heat Press
21