Raydan Home 23039 Manual De Instrucciones página 9

EN
11.- Operation:
-Turn the switch on before fan starts operating.
-The fan can rotate at three speeds as selected with the pendant switch:
The first time the switch is pulled the speed is MAXIMUM, the second corresponds to the MEDIUM
speed, the third is the LOW speed, finally the fourth is OFF.
-The second pendant switch allows the lighting to be switched off and on.
-The switch placed on the fan body allows controlling the direction of rotation of the blades and the
movement of the air (See figure).
NOTE: Make sure the fan is stopped before changing the direction of rotation. To prevent damage to
the motor or the user, do not press the switch while is in operation.
DINAMIC BLADE BALANCING KIT
PREFACE
Your ceiling fan may sometimes have wobble problem when operate due to irregularity in blades or the blade holders. Also, improper
assembly in the mounting system may cause some additional problem, also bearings crooked. The following procedure to remedy
such problem is strongly recommended by us from our past experience in handling the wobble problem:
Dynamic blade balancing kit for ceiling fans
I. Make certain that all blades are firmly screwed into the blade holder.
2. Make sure that all blades are firmly secured to the flywheel and check pitch of blade holders, all must be the same.
3. By looking up at the fan from below, check and be certain that none of the blade holders are bent so that none of the blades are out
of position. A correction can be made by very gently bending the blade holder back into position.
4. By the simple use of a household yardstick blade tracking can be checked, put the yardstick up against the ceiling vertically and even
with the outside leading edge of a blade. Note the distance of the edge of the blade to the ceiling, carefully turn the blades slowly by
hand to check the remaining blades. If blade is not in alignment, the blade holder may be gently bent up or down to be in line with the
other blades.
If by following all the steps and the wobble problem is not slowed a dynamic balancing needs to be done by the use of the balancing kit.
Follow the procedure listed below:
-Turn the fan on and adjust the speed control (usually high speed) setting to the speed which creates the greatest wobble.
-Turn the fan off Select one blade and place the balance clip on it, halfway between the blade holder and the blade tip on the rear edge of
the blade.
-Turn the fan on. Watch to see if the wobble is improved or worsened .Turn the fan off again and move the clip to another blade and test
again. Repeat this process with all blades and then note the blade which is the most improved.
-Move the clip back to the blade which showed the most improvement. Move the clip inward and outward on this blade and operate the
fan to find the position where the clip gives the most improvement.
-Next remove the clip and install a balancing weight to the top of the blade along the centerline near the point where the clip was
positioned. Use a sharp knife or razor to separate the weights.
Caution: Stay clear of the blades. If the clip, for any reason, is not secure, injury could result Dangerous