Technical Data - Shopseries RK9011 Manual Del Usuario

3.5A OSCILLATING SPINDLE SANDER

TECHNICAL DATA

Voltage:
Amps:
No load speed:
Protection class:
Table size:
Spindle stroke:
Oscillations per minute:
Max sanding height:
Weight:
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
1. UNPACKING
When unpacking, check to make sure that the item is
intact and undamaged.
2. INSTALLING AND CHANGING SANDING SLEEVES (SEE
A-F)
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
1) To install a Sanding Sleeve, you must first locate
the corresponding Sanding Spindle and Drum Washer
(12).
EXAMPLE: The 3/4" Sanding Sleeve goes with the 3/4"
Rubber Sanding Drum and the 3/4" Table Insert
2) First place the Drum Washer (12) over the Spindle,
then place the Table Insert (3) on the worktable in the
round recessed area. Next place the Rubber Sanding
Drum drum (11) over the spindle. (See A, B, C)
NOTE: The 1/2" Sanding Sleeve is the only sanding
sleeve that goes directly onto the spindle.
3) Place the Sanding Sleeve (10) over the rubber
Sanding Drum, and put the correct size spindle
washer (a) on top of that. Finally thread the hex nut
(1) Onto the Spindle and secure it by using a wrench.
(See D, E, F)
3. OPERATION (SEE G, H, I)
1) Turn the sander on by using the Switch (5). Always
run the sander for a few seconds before contacting
the workpiece. (See G)
2) Contact the workpiece with minimal pressure. If the
spindle sander is not removing enough material, try
10
a coarser grit sanding sleeve. Keep a firm grip on the
stock material as you move the stock material into the
120V~60Hz
spinning sanding sleeve.
3.5A
3) Occasionally check the sanding sleeves for tears,
2000rpm
wear or fraying. Replace if necessary. Stop using if
/II
sanding sleeve is damaged.
14-1/2˝ x 11-3/8˝
4) When finished working, turn off the switch. Remove
5/8˝
the safety lock (b) and store it out of the reach of
58 opm
children. (See G, I)
3-5/8˝
34Ibs
MAINTAIN TOOLS WITH CARE
maintenance.
1. STORING THE EXTRA RUBBER SANDING DRUMS:
The rubber sanding drums, which are not being used,
can be stored on the rubber sanding drum storage
area (7). (See J, K)
2. DUST EXTRACTION PORT (SEE L)
The Dust Extraction Port (C) maintains a clean
working environment. Attach a dust bag or a shop
vac to the dust extraction port.
Your power tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Remove the plug from the socket before
carrying out any adjustment, servicing or
ENG