Installation On A Desk - Yamaha RM-CR Manual De Instalación

INSTALLATION ON A DESK

Use the separately sold RM-MTL mounting accessory to install the unit.
Obtain four screws with a diameter of approximately 5 mm (M5 equivalent) that are
appropriate for the material and thickness of the desktop.
Carry out the installation through step 4.
Warning: Do not attach this product to anything other than the underside of a
If the unit falls, injury or damage might occur.
Caution: Installation must be performed by a qualified installer. During
• Choose hardware and a location that is well able to support the weight of this unit
• Avoid locations that are subject to sustained vibration
• You must use the specified installation accessory
• Perform periodic maintenance checks
1.
Using four commercially available screws approximately 5 mm in diameter, fasten
the metal fixture to the underside of the desktop.
In the illustration above, the upper part is toward the front.
Warning: You must use screws that are appropriate for the material of the
If the unit falls, injury or damage might occur.
desktop.
installation, pay attention to the following points.
desktop.
RM-CR Installation Manual
17