Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3 . Errors and possible solutions
Error pattern
Door does not open and close de-
pending on the time
Door does not open and close de-
pending on the light sensor
Door does not move down
Door does not fully move up and
always remains stationary, or door
does not fully move down and
always remains stationary
Door moves at the wrong times
F . USER-MAINTENANCE INSTRUCTIONS
1 . Cleaning / maintenance
Danger!
Risk of physical injury and material damage if used incorrectly!
• Before starting any cleaning work, disconnect the mains plug.
Check the ease of door operation frequently (at least weekly). Clean the guide rails and use lubricant if necessary. Remove dirt and any objects from the door's
closing area in order to protect the motor and avoid transporting dirt via the cord into the inside of the electronics unit. Regularly check the condition of the
cord for wear and replace it in good time. Use our replacement cord to do this (ref.no. 70552).
2 . Maintenance and repair
The device does not require maintenance, but should be thoroughly cleaned at regular intervals. In the event of a fault, the device must be taken out of use
immediately. If a repair is required, please contact a qualified electrician or send the device for repair to the manufacturer. A faulty connecting cable should
also only be replaced by the manufacturer or a qualified electrician. Only use original spare parts. If a battery symbol appears on the display, the batteries must
be replaced. After replacing the batteries, the time and date must be re-set.
3 . Technical data
Mains voltage
Batteries
min. slider weight
max. slider weight
External buttons
Power pack protection class
Device protection class
Power pack protection type
Device protection type
Possible cause
Timer is deactivated (time does not advance on
the display and 't-off' is shown)
The light sensor prevents the door opening as it is still
dark. (closed state always has priority)
Automatic mode is not set
(automatic mode is indicated by a small circle
at the top side of the display)
Light sensor is not set properly
Automatic mode is not retrieved
(automatic mode is indicated by a small circle
at the top side of the display)
Too little weight on the rope, either because
• the door is too light or
• the door is jammed and does not move down
Door is obstructed, making it difficult to move
(for example: Dirt in the guide rail)
Current time set incorrectly
Opening and closing times not set for weekends
100-240 Volt / 50/60 Hz
4 x type AA
1.1 lbs
5.5 lbs
A normally open contact each for Up and Down
II
III
IPX0
IP33
Solution
Hold down menu button and OK button
at the same time for 5 seconds
Unplug the light sensor or set the light sensor correctly
• press arrow upwards when door is open
• press arrow downwards when door is closed
A middle position should be set (depending on desired
dimming) on the dial. Slowly test where the ideal set-
ting is beginning from the middle position.
• press arrow upwards when door is open
• press arrow downwards when door is closed
• use other door/slider
• align guide rails
• use lubrication
• add weight to door
Door must be smooth-running.
• remove dirt
• align guide rails
• use lubrication
• add weight to door
Time correctly set in the menu
The correct times must be set in the menu for
both week days and weekends
4 . Accessories / replacement articles
Réf.no. 70560 Sliding door 220 x 330 mm, incl. guide rails
Réf.no. 70570 Sliding door 300 x 400 mm, incl. guide rails
Réf.no. 70551 Pulleys, pack of 4
Réf.no. 70552 Replacement cord with bead
Accessories and replacement articles must be ordered separately.
FOR HOUSEHOLD USE ONLY .
9
Publicidad
Tabla de contenido
