Setting Alarm Time - Envira Station DWS-210 Manual De Instrucciones E Información De Garantía

Now you will select the calendar settings-
5. Select Day - Use the " + , - " buttons located on the back of the home
receiver to adjust day setting. Press "SET" button to confirm your
selection.
6. Select Hour - Use the " + , - " buttons located on the back of the home
receiver to adjust hour setting. Press "SET" button to confirm your
selection.
7. Select Minute - Use the " + , - " buttons located on the back of the
home receiver to adjust minute setting. Press "SET" button to confirm
your selection.
8. World Time Offset - Use the " + , - " buttons located on the back of the
home receiver to adjust "World/Time Offset". Press "SET" button to
confirm your selection.
WORLD TIME FUNCTION
You can view the world time by pressing "SET" button, "World" on the LCD
will be shown.
FAHRENHEIT/CENTIGRADE SELECTION
You can now select either Fahrenheit or Centigrade temperature readings.
Hold the max/min button for 3 seconds to toggle between Centigrade or
Fahrenheit readings.

SETTING ALARM TIME

This unit features two alarms (Alarm 1 and Alarm2). To select one press the
"AL" button. Your selection will be shown on the display. To enter alarm time:
1. Hold the "AL" button for 3 seconds. Press " + , - " to enter the desired
Hr/ Min values and press "AL" to confirm setting.
2. To view alarm time - Press "AL" button. Alarm time will display for 5
seconds and then resume to normal clock thereafter.
3. The home receiver will provide either a daily alarm, which last for 2
minutes or a snooze mode where the alarm will repeat every 5 minutes
until manually cleared (see SNOOZE/LIGHT section below).
4
SNOOZE/ LIGHT
1. Press the "SNOOZE/ LIGHT" button (Zz/ light icon
button) for an extended backlight.
2. In snooze alarm mode, press this button to trigger a
repetitive snooze alarm.
3. When normal alarm mode is selected, press the "SET",
"ALERT", "+" or "-" buttons to turn off alarm for one day.
MAX/ MIN MEMORY SETTINGS
1. Press "MAX/ MIN" button to view the maximum values for
5 seconds. Press again to view the minimum values.
2. To clear the memory record, press "CLEAR" while the
respective values displaying on screen.
TEMPERATURE, PRESSURE AND HUMIDITY
TREND INDICATORS:
You will see one of 3 icons;
will indicate Rising readings if it changes more than
1 degree or 1% relative humidity in an hour
will indicate Steady readings
will indicate Falling conditions if it is more than
1 degree 1% relative humidity in an hour
These readings are refreshed every hour.
WEATHER FORECAST WITH STORM ALERT
The built-in sensor will read the atmospheric pressure and
calculate the weather conditions of the next 12 hours. These
conditions will be displayed as; Sunny, Partial Sunny, Cloudy,
Rainy, Stormy, Icy at the top of the LCD display.
OFFSETTING AIR PRESSURE FOR
WEATHER FORECAST
To ensure accurate weather forecast under different altitude
situations, you should first enter the existing weather
condition manually. Press the "MAX/MIN" button to select
5