Mounting Instructions; Maintenance And Care Instructions - Envira Station DWS-210 Manual De Instrucciones E Información De Garantía

the current conditions. Press "CLEAR" to confirm. The home
unit will ask you to enter the existing weather condition right
after installing batteries for the first time.
After the initial step or in case the weather forecast deviates
from the existing conditions, you can still recalibrate the unit.
1. Hold "CLEAR" button for 3 seconds to enter the pressure
offset mode. The weather icon will flash.
2. Select the existing weather condition by pressing
"MAX/MIN" button.
3. Press "CLEAR" to confirm and exit.
4. The unit is now calibrated to the existing pressure and
weather conditions.
LOW BATTERY INDICATION
Low battery indication is available for the home receiver and
the remote sensor. Replace the batteries and follow the setup
procedure as mentioned in this instruction manual.

MOUNTING INSTRUCTIONS

Both the Home Unit and Remote Sensor come with a table
stand or they can be wall mounted.
Table Top -
For the home unit, simply attach the stand provided.
For the remote sensor, simply fold out the attached stand
from the mounting bracket.
Wall Mounting -
For the Home Unit - Remove the table top stand from the
bottom of the unit. Fix a screw (not included) into the desired
wall and place the home unit onto the screw using the back
side hanging hole.
For the Remote Sensor - Fix two screws (not included) into
the desired hanging location using the mounting bracket
holes on the remote sensor as a template. Ensure that the
screws are placed vertically (in a straight line up/down) along
6
the surface and that there is proper distance between each screw to hang the
mounting bracket. Align the hanging holes of the mounting bracket with the
two screws and place unit onto the screws.

MAINTENANCE AND CARE INSTRUCTIONS

• Extreme temperatures, shock or areas of unusual vibration should be
avoided to prevent damage to the units.
• Clean the units using only a soft, damp cloth to wipe. Do not use
solvents, abrasives, detergents or other strong cleaning agents. After
cleaning, wipe surfaces with a dry cloth.
• Do not submerge units in water or other liquids.
• Do not subject the units to extremely severe temperatures - DO NOT
PLACE UNITS INTO OVENS, FREEZERS or MICROWAVE UNITS.
NOTE: Opening the housing (other than the battery compartment) of
either the Remote Sensor or the Home Unit will invalidate your warranty.
Do not attempt to repair this unit – There are no consumer serviceable
parts.
TROUBLE SHOOTING
Indoor and Outdoor temperatures do not match when
placed next to each other -
Each sensor is manufactured to be +/- 1 degree in accuracy under normal
conditions. So it is possible to have up to two degrees difference shown on
the separate temperature sensors (one could be "+1 degree" and the other
"-1 degree". Additionally, the calibration curve is different between the two
units because of the greater temperature range of the outdoor sensor.
Errors are usually noted on the extreme ends of the temperature ranges.
Base unit is not accepting remote transmissions -
The units may not be properly synchronized or the batteries may need to be
replaced. See "SETTING UP THE WIRELESS THERMOMETER" section
beginning on page 2 of the instructions for detailed instructions. With the
two units next to each other, attempt synchronization. Remember to always
place the remote sensor within the effective transmission range and away
from large metal surfaces.
7