SALKI SEK 100W Manual De Utilización página 16

KIT SEK 100W
EN
PARTS
1 Soldering Tip
2 Screw
3 Light
4 Switch
5 Handle
6 Power cord
TECHNICAL INFORMATION (SEK 100W)
Power
Voltage
Frequency
Insulation
TECHNICAL INFORMATION (30W)
Power
Voltage
Frequency
Insulation
USER'S MANUAL
Before using the Gun, make sure your voltage and electric current frequency match with the technical information above. The numbers
shown here refer to the illustration above.
1. Using the Cord (#6), connect the gun to a 230V/50Hz power supply.
2. Holding the gun by the Handle (#5) place the Solder Tip (#1) on the point you wish to solder.
3. Turn on the Switch (#4) and the Light (#3) will shine on.
4. It will take 6 to 8 seconds for the gun to reach temperature (230 degrees C).
5. When finished soldering, turn off the Switch (#4).
As you depress the Switch (#4) the gun will continue to heat up. Do not depress the Switch (#4) for long periods of time while soldering.
When you let go of the Switch (#4), the temperature diminishes quickly. Depressing the Switch (#4) quickly raises the temperature.
Keeping the gun at a constant temperature extends the life of the gun.
Before using the gun, lubricate the Soldering Tip (#1).
This gun is energy efficient as it reaches temperature very quickly.
The shape of the Soldering Tip (#1) allows you to partially contact the work piece.
MAINTENANCE
The gun and the Soldering Tip (#1) are designed to easily disconnect for occasional replacement.
Tip Replacement
Unscrew the two screws connecting the Soldering Tip (#1) to the gun. Pull off the old tip, replace it, and replace the two screws.
Attention:
1. Before using, verify the electricity requirements and visually inspect the gun and your work stand.
2. Never use the gun in the rain.
3. Make sure no foreign objects are in the gun's internal parts.
4. Never dismantle the gun. Contact an authorized service technician.
5. Disconnect the gun from the power source when not in use.
6. Intended use: The product is intended for indoor domestic use.
Instrucciones salki KIT SEK 100W v03.indd 18
100 W
220-240V~
50 Hz
Class II
30 W
230-240V~
50 Hz
-
16
1
2 3
4
5
6
18/08/14 12:44