CamCaddy CC1005 Manual Del Usuario página 3

SPECIAL NOTE
If the battery to be charged is completely flat and no
LED's 4, 5, 6 or 7 (fig 1) are glowing when the central
button 9 (fig 1) is pressed, it is possible to insert the
battery into CamCaddy in a reverse polarity position
(see step d) without realising it. In this circumstance
you should connect CamCaddy to a power source as
previously described. Within 5 minutes you will either
see LED 4 glow GREEN which will indicate that you
have correct polarity and charging is commencing
normally, or no LEDs glowing at all – in which case you
should change the position of switch 8 to reverse the
polarity and commence charging.
Warning
1. Keep CamCaddy away from fi re, water and any form of
moisture to ensure damage and injury do not result.
2. Any severe shock or impact may result in damage and
will invalidate the warranty.
3. It is forbidden to dismantle CamCaddy except by Solar
Technology personnel or agents appointed by Solar
Technology. Any sign of tampering will result in the
warranty being invalidated.
Warranty
CamCaddy is supplied with a 12 month warranty. Should a
failure occur during this time Solar Technology International
Ltd will repair or replace any faulty part/s, at its discretion
upon a copy of the proof of purchase being provided. Solar
Technology International Ltd does not accept liability for
any 3rd party damage how so ever caused or any costs
associated with the return of faulty products.
To make a warranty claim please telephone
Solar Technology International Ltd on
+44 (0) 1684 774000 or support@solartechnology.co.uk
These warranty conditions in no way affect your statutory
rights. A full set of Solar Technology International Ltd terms
and conditions are available on request.
Using CamCaddy Tags (included) to charge
Blade Style Batteries
CamCaddy Tags are for use with batteries whose terminals
are so narrow as to be ordinarily uncontactable by
CamCaddy power pins (F & G)
A
C
B
D
ADAPTERS FOR BLADE STYLE BATTERIES
a. Identify the positive and negative terminals (A & B) on
the underside of the battery - as shown left, they are
clearly marked as the two outside 'slots' of the four
terminals.
b. Position the CamCaddy Tags so that the Terminal
Contacts (C & D) are uppermost (as shown), then insert
them fully into the positive and negative slots (A & B)
on the battery.
c. Turn the assembly upside down so that the battery
terminals are on the bottom, pull back the Slider Bar
(E) on Camcaddy, and lower into place so that the Tags
make contact with CamCaddy's Power Pins (F & G),
taking care to ensure that each Power Pin
touches only one Tag. Release the Slider Bar to hold
the battery in place for charging.
2
A B
E
G
F