PRODUCT SPECIFICATIONS
SPECIFICATIONS
Max. flow rate: 1.2 GPM (4.5 LPM) at 60 PSI
ASME A112.18.1/CSA B125
NSF 61-9
Oil rubbed bronze finish
ASSEMBLY INSTRUCTIONS
1.
Shut off water supply and remove old
faucet.
NOTE: Each valve stop should be
turned clockwise.
2.
Remove the preassembled mounting
nuts (1) from the faucet body (2) and
place the base plate (3) and faucet
body (2) in position on the sink.
NOTE: if the sink surface is uneven,
use silicone sealant (not included) to
create a watertight seal.
From under the sink, thread the
mounting nuts (1) onto the faucet
body (2). Tighten the mounting nuts
(1). Do not overtighten.
3.
Connect a 1/2 in. IPS faucet connector
or coupling nuts (not included) with 3/8
in. O.D. ball-nose risers (not included)
to the water supplies underneath the
sink using wrenches (not included).
NOTE: Refer to the local plumbing
codes for permissible types of water
supply lines.
4.
Remove the stopper (1) and flange (2)
from the pop-up assembly (3). Screw
the nut (4) all the way down onto the
pop-up assembly (3) and then push
the gasket (5) down.
www.homewerksww.com
1
2
2
1
3
4
1
2
5
4
3
Ceramic cartridge
Manufactured to include no more than 0.25% weighted average lead
content on wetted surfaces
5.
Apply silicone sealant (not included)
to the underside of the flange (1).
6.
Insert the pop-up assembly (1) into
the sink and screw the flange (2) onto
the pop-up assembly (1). Ensure the
pivot hole is facing the back of the
sink. Tighten the nut (3) and remove
the pivot nut (4).
3
7.
Insert the stopper (1) onto the sink.
Remove the preassembled horizontal
rod (2) and clip from the lift rod strap
Install the horizontal rod (2) into the
pop-up assembly (3) and through the
hole of the stopper (1). Install the
pivot nut (4) onto the horizontal rod
(2) and hand-tighten it back onto the
pop-up assembly (3).
8.
Re-attach the lift rod strap (1) to the
horizontal rod (2) using the clip (3).
2
SPECIFICATIONS
5
6
2
3
7
1
D
3
8
1
4
1
4
I
2
J
H
1
3
2