Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
9.
Insert the lift rod (1) through the
faucet body (2) and into the lift rod
strap (3). Tighten the screw (4) on
the lift rod strap (3).
TROUBLESHOOTING
PROBLEM
There is a leak from under the
handle or there is a leak from the
spout when the faucet is off.
There is a leak from the aerator
when the faucet is off.
The aerator had irregular or
reduced water flow.
CARE AND MAINTENANCE
Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the finish and void your warranty.
ROUGH-IN
1/2"-14NPSM-2A
www.homewerksww.com
9
2
POSSIBLE CAUSE
The bonnet nut is not tight enough.
The cartridge is damaged.
The aerator does not fit correctly on the faucet.
The aerator is dirty.
9-3/8"
10.
After the installation is complete,
remove the aertator from the faucet
1
body (1) using a coin (not included).
Turn on the water supply and allow
both hot and cold water to run for at
least one minute each. While water
is running check for leaks. Replace
aerator.
4
3
CORRECTIVE ACTION
1. Remove the handle and retighten the bonnet nut.
2. If the problem occurs after the retightening the bonnet nut, call customer service for
a new cartridge and replace the old one.
1. Reinstall the aerator.
2. Call customer service for a new aerator assembly and replace the old one.
1. Remove the aerator and clear debris.
3
10
A
6-1/2"
4-5/8"
2-5/8"
Publicidad
Tabla de contenido
