Dell Networking C1048P Guía De Introducción página 31

10/100/1000BASE-T ports on the front panel are numbered from 0 to 47,
starting with the lower port on the far left side (facing you). Even-numbered
ports 0-46 are on the bottom; odd-numbered ports 1-47 are on top. The two
10GbE SFP+ ports are numbered 48 and 49.
Figure 9. C1048P Port Numbering
1. C1048P 10/100/1000BASE-T
ports 0-47
Next Steps
After you complete the initial C1048P provisioning described in this section,
you can configure L2/L3 and other software features on the C1048P from the
C9010 console CLI. For detailed information, refer to the C9000 Series
Configuration Guide.
Once the C1048P is online, you can enter the connect-pe pe pe-id
command on the C9010 console to remotely log in to the C1048P CLI. To
log in, enter the user name peadmin and the password calvin. After logging
in, you can enter show and stack renumbering commands on the C1048P.
To move through command modes in the C1048P CLI, refer to the
Command Modes section in the Dell Networking C9010 Getting Started
Guide.
29