Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
1. Mount the 4 holes of the flange to the 4 holes in the base. Then, insert the bolts into the holes, re-tighten the bolts and nuts.
Slide the base cover down onto the round base flange.
2. Insert the motor into the top of the bracket.
3. Fit the rear grille to the engine housing. Secure with 4 screws.
4. Mount the fan blade on the motor shaft with the shaft screw. Secure the nuts.
5. Mount the front grille with the back and went with the clips on the grill.
HOW TO USE
A. The speed, direction and movement of the fan can be controlled with the following instructions:
1. Position 0 - Off
2. Position 1-Minimum Speed
3. Position 2 - Average Speed
4. Position 3 - Maximum Speed
B. To move the fan, push the back button. If it is no longer needed, lift it up to stop it.
C. You can alter the height of the fan by loosening and adjusting the double cone, bringing the extension bar to the desired
height.
CLEANING
Make sure the fan is in the "OFF" position.
Use only a damp cloth to gently clean the fan.
DO NOT immerse the fan in water and never let water seep into the motor housing.
Remove the front grille for cleaning.
To access the fan blades, remove the front grille and the set screw.
DO NOT use gasoline, paint thinner, or other chemicals to clean the fan.
Wipe fan blades and front grilles with a damp soft cloth.
Replace the blades tighten the locking screw and firmly attach the front grille.
Publicidad
