Installing The Canopy Housing; Assembling And Mounting The Fan Blades, & Adapter/Switch Hsg - Lauren Brooks Bayhill LB250VZ Manual Del Propietario Lea Y Guarde Estas Instrucciones

NOTE: This step is applicable after the necessary wiring
is completed.
▲WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
1.
2. Securely attach and tighten the Canopy Screw Cover
over the shoulder screws in the Hanger Bracket utilizing
the keyslot twist-lock feature (Figure 1b).
Assembling and Mounting the Fan Blades, & Adapter/Switch Hsg
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
▲WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in between
the rotating blades.
1. Remove and discard the (rubber) motor "stops" by
removing the four screws. (Figure 1)
Blade & Blade Holder Assembly:
2. Lay the side of the blade holder on a flat surface with the
inside of the blade holder facing up. This is the side with
the threaded posts.
3. Position the wood blade over the blade holder with the
threaded posts showing. Make sure the bottom edge of
the blade is fully seated against the blade holder.
4. With a Phillips screwdriver, tighten pan-head screws
with fiber washers and flat washers to secure the blade.
(Figure 2)

Installing the Canopy Housing

NOTE: Supply wires and fan wires omitted for clarity.
Figure 1a
Fan Blade
8
Figure 1b
Figure 1
Blade Holder
Figure 2