Publicidad
Idiomas disponibles
Idiomas disponibles
Beep
Press
for long time to choose BEEP's on or off.
Laser continuous
Press and hold down the key when switching on the device until the character
appears permanently in the display with beep sounds. Every further press of the
releases a distance measurement
continuous operation off.
OPERATION
Switching on or off Switches on the instrument and laser. The display shows the battery
symbol until the next button is pressed .
Pressing this button for longer switches the instrument off. The instrument switches off
automatically after 3 minutes of inactivity.
CLEAR button
The last action is canceled. While making area or volume measurements, each single
measurement can be deleted and remeasured in series. Reference setting The default reference
setting is from the rear of the instrument.It will show
button
to take the next measurement from the front edge. The display will show
Press this button, the rear reference is set again.
MEASURING
Single distance measurement
distance
measurement.
Minimum/maximum measurement
This function allows the user to measure the minimum or maximum distance from a fixed
measuring point.lt can also be used as to determine spacings. It is commonly used to measure
room diagonals ( maximum values ) or horizontal distances ( minimum values ) or the difference of
maximum and minimum.
Press and hold down this button until you hear a beep. Then slowly sweep the laser back and
forth, up and down over the desired target point - ( e.g. into the comer of a room ).
Press to stop continuous measurement. The values for maximum and minimum distances are
shown in the display as well as the last measured value in the summary line.
Press the key and hold to switch the device and Laser
Press to activate the laser.
The result is displayed immediately.
on the display.
13
Press long this
Press again to trigger the
key
Publicidad
