LiMURAL LM-Y2 Operación Manual página 5

5. Cutter Cleaning and Maintenance
Blade Cleaning
1.Use the cleaning brush to brush off hair clippings
after every use. To completely clean the hair
clippings between the upper and bottom blades,
loosen the screws on the lower blade with a
screwdriver.
2.After the cleaning process, reassemble the two
blades. When you tighten the screws, make sure the
blades are realigned in the correct position.
①Make sure that the top of the upper blades teeth
are at 0.45-2mm lower than the top of the bottom
blades. This is important as it prevents the upper
blade from touching your skin directly.
②The leftmost tooth of the upper blades should be
aligned with the second to last left tooth of the
bottom blade.
③The rightmost tooth of the upper blade should be
aligned with the first tooth of the lower one.
Blade Maintenance
Lubrication oil should be applied regularly to ensure
the stable performance of the clippers. Apply 2-3
drops of oil on the areas indicated by the arrows in
the picture. This is the position where upper blades
and lower blades move back and forth.
6. Use the Rechargeable Mode
1.Connect the USB cable to the clippers charging outlet. Make sure the clippers are turned off,
and put the USB adapter plug into the power socket.
2.The clippers will start charging when the charging indicator light comes on; when the red
light turns green ( or blue), it is fully charged.
3. It can be used with or without a cord.
04
English
Clipper-Führungskämme
3/6/10/13/16
/19/22/25mm
1. Komponenten
Untere Klinge
Obere Klinge
Klingenhebel
EIN/AUS-Schalter
Der Adapter ist nicht
im Lieferumfang enthalten.
Ladeanzeige Standard 5V/USB
-Ladeanschluss
Reinigung- Schmierölv Kamm Standard
sbürste 5V/USB-
Ladeanschluss
05
Deutsch
Friseur -
Regen-
Reinigun-
schirmumhang
gsbürste