HITWAY 14F004 Manual De Usuario página 5

FOLDING OPERATION DIAGRAM
1: The vertical tube can be folded by
pressing the red button on the vertical
tube folding quick release and then
release the quick release.
3: The direction of the handlebar can
be adjusted through the handlebar
adjustment quick release.
6: Press the pedal inward with your hand, and then flip it up, the pedal can be
folded.
Please pay attention to the direction in which the
battery cover is placed, there is ALX on the right side
of the battery cover.
A perspective
How to take out and install the battery:
a. Take out the battery: When the frame is folded, refer to the A
perspective view. Use a Phillips screwdriver to loosen the two fixing
screws of the battery cover, and then open the cover, as shown in
Figure 3. Then as shown in Figure 4, use the No. 3 hex key to screw
the two battery fixing screws under the drive frame, and after
removing the screws, you can take out the battery, as shown in
Figure 5;
b. Install the battery: the order of the battery removal method is
reverse. Before fixing the battery cover, check the direction of the
cover and make sure that the ALX word is on the right, otherwise
the battery cannot be connected to the left controller.
2: The seat tube can be adjusted up
and down for quick release and the
height of the seat tube can be adjusted.
4: Vertical pipe adjustment and quick
release can adjust the height of the
vertical pipe.
Press in The state of the pedals folded
Battery cover
Fixing screw
Figure 3
Battery fixing screw
Illustration after opening the
battery cover
3
5: Pull the buckle up and release the
quick release, the frame can be folded.
The folded state of the frame
Figure 4
Figure 5
A perspective
view