Fumpa Pumps miniFumpa Manual Del Usuario página 4

miniFumpa is not intended to be used to continually
pump up tyres.
miniFumpa automatically turns off
after 50 seconds of use. If the user
requires more inflation, simply turn the
unit back on.
Do not repeatedly turn miniFumpa on
and off! The unit will sound an alarm if
the ON/OFF button is being abused.
The maximum pressure a tyre can be
inflated to is approximately 120 psi (~830
kPa or ~8.3 Bar). The unit will struggle to
pump up tyres beyond this pressure.
Approximate pump up times
700x23c 0-100psi:
0-105psi:
700x25c 0-90psi:
0-100psi:
700x28c 0-90psi:
Disconnecting the unit from a tyre
Disconnect miniFumpa from the valve by firmly
pulling miniFumpa away from the valve.
miniFumpa is powered via a rechargeable lithium
battery. miniFumpa includes battery protection
circuitry to ensure safe operation of the battery. For
a once-a-week user, the battery should last a
number years.
During use miniFumpa's button will
glow red if the unit is fully charged. If
the battery's charge is between 40-95%,
the button will flash slowly. If the
45 seconds
50 seconds
42 seconds
50 seconds
55 seconds
Battery
charge is less than 40% the button will
flash fast and miniFumpa should be
recharged.
Only charge miniFumpa via USB
connection. Once fully charged,
disconnect it from the charger.
Continual use of miniFumpa without
allowing time for heat to dissipate will
significantly reduce the life of the battery!
Battery replacement should only be
carried out by trained technicians. Do not
open the unit.
The table below lists the number of tyres that can be
pumped with a fully charged battery before it
requires recharging.
Approximate tyre pumps on a full charge
700x23c tyre 0-100psi:
700x25c tyre 0-100psi:
700x28c tyre 0-90psi:
Troubleshooting
miniFumpa won't
turn on
miniFumpa is warm
to touch
miniFumpa is
making a noise like
a siren.
Air escapes from
around the Nozzle
2.7 tyres
2.5 tyres
2.0 tyres
Battery requires charging.
This is normal. If miniFumpa
becomes very hot, turn it off
and allow it to cool.
Turn it off, wait 10 seconds,
then turn it back on.
A new Seal inside the Nozzle
is required. Go to