Publicidad
Assembly Instructions for Push Bar "Escape I"; "Escape III"; "Escape IV" and "Escape V"
References: 45000; 45003; 45005; 45010; 45020; 45021; 45022; 45030; 45031; 45032; 45035; 45036; 45040;
45041 and 45042.
Attention:
This device is manufactured according to standard EN 1125:2008, which ensures users operation with maximum security.
No changes are allowed, except those described in these instructions.
Scope of application
on doors
Standard
Specials
Installation and Fitting Instructions
This Anti-panic bar must not be applied on non-hinged doors.
A.1.
A.2.
blinding.
by the producer for this type of door.
It is recommended to verify that the door construction allows the use of the device, i.e. to verify that offset
hinges and engaging leaves allow both leaves to be opened simultaneously (See A.4.), or to verify that the gap
elements do not interfere, etc.
A.3.
approved for.
A.4.
inhibit the correct operation of the panic exit device.
A.5.
essential to check that either leaf will open when its panic exit device is activated and also that both leaves will
open freely when both panic exit devices are operated simultaneously.
Where panic exit devices are manufactured in more than one size, it is important that the correct size is
A.6.
selected.
A.7.
Category 2 (Standard projection) panic exit devices should be used in situations where there is restricted width
A.8.
or laminated glass.
A.9.
A.10.
by the exit device producer.
A.11.
instructions should be passed on by the installer to the user. See Annex C
A.12.
premises will be young children, consideration should be given to reducing the height of the operating element.
A.13.
The horizontal bar should be installed so as to provide the maximum effective length.
A.14.
that no projection of the bolt heads, when in the withdrawn position, can prevent the door swinging freely.
Maximum
Maximum
weight
height
200 Kg
2.500 mm
200 Kg
3.000 mm
7
Maximum
Temperatures
width
limit
1.300 mm
-10 ºC +60 ºC
1.500 mm
-10 ºC +60 ºC
EN
Publicidad
